Had this truck "plugged in" to check for the fault, turned out to be the left, (drivers side), front sensor that needed replacing. Truck was in a very minor "bumper bender".
Here's what I've done;
Unplugged the battery, waited 10 minutes, replaced sensor with new one, turned truck on, still same message. Do I need to erase the code with a reader and if so, would an inexpensive reader be enough to do this?
Steve
Here's what I've done;
Unplugged the battery, waited 10 minutes, replaced sensor with new one, turned truck on, still same message. Do I need to erase the code with a reader and if so, would an inexpensive reader be enough to do this?
Steve