jQuery not supported.



Found 5191 matches: brake

Next

New Owner of an Old Sierra

... housing standoff and replaced various burned out or missing bulbs ⋅ Replaced rear rotors & pads ⋅ Replaced frozen rear brake caliper ⋅ Replaced & adjusted parking brake shoes ⋅ Replaced shocks & lubed front suspension ⋅ Replaced ...
by patman
26 minutes ago
 
Forum: Member Introductions
Topic: New Owner of an Old Sierra
Replies: 3
Views: 22

Exhaust Beware

... a mistake, posted such on here, and went about my business. About 3 months later I started to notice a metallic rattle at start up and idle with brake depressed (low rpms). After investigation I discovered that the problem was internal to the muffler and it was getting worse. After just 2-3 weeks ...
by shawnrobbins
Today, 2:55pm
 
Forum: Exhaust
Topic: Exhaust Beware
Replies: 13
Views: 244
by SilveradoSierra.com
Today, 2:55pm
 
Forum: Exhaust
Topic: Exhaust Beware
Replies: 13
Views: 244

Re: Bahndrvr's 07 NNBS CCSB Build:)

Well - went ahead and threw the SkyJacker 5-7 inch lift Brake lines on a card - figured btter do it now as opposed to having to replace all the brakes on the truck.

Try not to use credit but in this case I think it's alright.
by bahndrvr
Today, 2:53pm
 
Forum: Uncategorized Truck Topics
Topic: Bahndrvr's 07 NNBS CCSB Build:)
Replies: 63
Views: 2738

Re: Bahndrvr's 07 NNBS CCSB Build:)

Rained most of the weekend so didn't get to wash/claybar/compound/wax it's still dirty and looking bad... In other news , found those Brake lines and great thing, started hearing noise out of my brakes on Saturday so when I got to a gas station out of the rain took a look and seems the pads ...
by bahndrvr
Today, 1:58pm
 
Forum: Uncategorized Truck Topics
Topic: Bahndrvr's 07 NNBS CCSB Build:)
Replies: 63
Views: 2738

Mag-Hytec rear diff cover added this weekend

... is for the traction control. I had to round off the end of the bracket and enlarge the hole a small amount. The second bracket holds the emergency brake cable and the vent tube for the rear end. I cut the back section off and added a line clamp to hold the emergency brake cable. I did this so the ...
by Tblazer123
Today, 5:13am
 
Forum: Transmission/Drivetrain
Topic: Mag-Hytec rear diff cover added this weekend
Replies: 1
Views: 98

Re: brake light wiring

You should get a wiring diagram to see which wire you should tap into.
by ASTE25
Today, 4:21am
 
Forum: Electrical
Topic: brake light wiring
Replies: 1
Views: 121

Re: Installing a Double DIN into a 2013 Silverado Advice Nee

... OnStar volume adjustment Retained accessory power output (R.A.P.) Reverse Wire output VSS (Vehicle Speed Sense) output Illumination output Parking brake output Includes antenna adaptor Retains lane departure warning system Retains OnStar Turn-By-Turn voice prompts In package updatable using the ...
by 13blcksilverado1500
Today, 3:02am
 
Forum: Mobile Electronics
Topic: Installing a Double DIN into a 2013 Silverado Advice Needed
Replies: 84
Views: 6210

Re: Installing a Double DIN into a 2013 Silverado Advice Nee

... is pretty crappy and when you display it onto the larger screen the quality sucks. The harness that you tap into from my research is above the brake pedal. Just tap into the correct wire and attach it to the camera input on your pioneer. My only concern is if the factory blue tooth will still ...
by dbmachine
Today, 2:49am
 
Forum: Mobile Electronics
Topic: Installing a Double DIN into a 2013 Silverado Advice Needed
Replies: 84
Views: 6210

Trailer Lights

So, weird problem. I have a 1998 Gmc Sierra, and when I hook up to a trailer, the turn signals on the trailer are switched when the brake is engaged. With out any brake applied, the turn signals work as they should, and the brake works fine without any signal on. It's only when the brake ...
by 98sierra
Yesterday, 8:54pm
 
Forum: Towing/Trailers
Topic: Trailer Lights
Replies: 1
Views: 115

Cruise works intermittently and rain dependent

... little amount of moisture would cause problem ) and then it eventually just went altogether (no engagement, no indicator light). I've read that brake light switch is common culprit but it seems the lights work fine, light on immediately with minimal foot pressure. Thanks in advance for any and ...
by keithdavio
Yesterday, 6:56pm
 
Forum: Electrical
Topic: Cruise works intermittently and rain dependent
Replies: 0
Views: 91
Next

More Results

Return to advanced search

It is currently May 20 2013, 9:29pm

Login  •  Register
SHOP TALK (Live Chat)
Sitewide News Sitemaps & Feeds