jQuery not supported.



Found 875 matches: components

Next

Re: Is my height stock other than front cranked? 01 2wd 2500

... geometry and you will need an alignment regardless..nows a time to upgrade your upper control arms to higher angle ones and beefier steering components
by RIPPEDK20
Yesterday, 6:56pm
 
Forum: Suspension
Topic: Is my height stock other than front cranked? 01 2wd 2500HD
Replies: 5
Views: 191

Clarion XC1410

... know its new so reviews are difficult to come by. Thanks for any input. Also while we are on the topic, this is gunna be my first time installing components, where do you guys end up putting the little crossover box and do you guys usually use the factory speaker wire coming down from the tweeter?
by Tuglife
Jun 16 2013, 3:18pm
 
Forum: Mobile Electronics
Topic: Clarion XC1410
Replies: 2
Views: 63
by SilveradoSierra.com
Jun 16 2013, 3:18pm
 
Forum: Mobile Electronics
Topic: Clarion XC1410
Replies: 2
Views: 63

Upgraded my sounds! 2011 Silverado LTZ Bose

... No I don't work for them and I won't get a dime for saying it. I went into a shop and heard them head to head with some Focals and Audison components. The Hertz got boxed up and came home with me. I did 6.5 components in front doors. 6.5 coax in rear doors. I am using my 12" JL 12w3v2 ...
by Firewalker688
Jun 16 2013, 5:35am
 
Forum: Mobile Electronics
Topic: Upgraded my sounds! 2011 Silverado LTZ Bose
Replies: 5
Views: 133

Fuel Pump has died!?

... issue with the silverado. I am a relatively new owner and have only done a bit of work, so not sure of other possible causes. is there any other components that could kill the fuel pump? edit: o yea wanted to mention that the CEL is not on
by cat4lyst
Jun 11 2013, 4:57am
 
Forum: Vortec 5300 5.3L V8
Topic: Fuel Pump has died!?
Replies: 10
Views: 225

Re: a few questions about a coolant flush?

... lifetime. However, when you do your mix and start adding fluid back to it, you could run it in order to get the fluid moving through the different components of the engine where antifreeze normally flows and then as you rev the engine, you will see the level lower within the radiator itself. I ...
by Onlyina_Chevy
Jun 11 2013, 4:35am
 
Forum: Engine
Topic: a few questions about a coolant flush?
Replies: 2
Views: 106

Re: Added new stereo/lighting/etc

... Yes I did it all myself. Thanks! The "bypass" wasn't hard due to having the PAC RP5-GM31 harness. I was able to keep all of the Bose components in place and still functional (if need be). I even ran new speaker cables through the factory locations so I was able to keep the factory ...
by cruisin_n_style
Jun 11 2013, 4:06am
 
Forum: Mobile Electronics
Topic: Added new stereo/lighting/etc
Replies: 13
Views: 718

Re: Bad misfire

So, replacing the components listed fixed the problem and now it is back again?
by ASTE25
Jun 09 2013, 8:06pm
 
Forum: Vortec 4300 4.3L V6
Topic: Bad misfire
Replies: 15
Views: 348

Re: Oil Life Indicator -- Accurate when set properly??

... thickness over a wide range of operating temperatures - anti-oxidant, to keep the oil from thickening - corrosion inhibitors, to protect engine components - anti-wear - anti-foam - detergents, to suspend solid particles. What Makes Oil "Wear Out?" If you were to start out with a crankcase ...
by Z15
Jun 09 2013, 5:21pm
 
Forum: Vortec 5300 5.3L V8
Topic: Oil Life Indicator -- Accurate when set properly??
Replies: 22
Views: 929

Re: 2 or 4 wheel alignment after leveling kit?

I always put all 4 heads on and check tire pressure and steering and suspension components before the alignment and make a testdrive after the alignment. If a customer is asking for a 2 wheel alignment, i send him down the street to the tire shop. He'll be back ...
by ThomasG
Jun 08 2013, 7:43pm
 
Forum: Suspension
Topic: 2 or 4 wheel alignment after leveling kit?
Replies: 21
Views: 810

Re: P0300 - good fuel pressure!

... Rough Idle, Stalls, Engine Cranks but Does Not Run, SES/Check Engine Light On, DTC P0300 Set (Inspect Distributor Ignition(DI) System Components, Replace as Necessary) - (Jan 28, 2005) Subject: Poor Engine Performance - Misfire, Rough Idle, Stalls, Engine Cranks but Does Not Run, Service ...
by retg
Jun 08 2013, 4:01pm
 
Forum: Vortec 4300 4.3L V6
Topic: P0300 - good fuel pressure!
Replies: 9
Views: 185
Next

More Results

Return to advanced search

It is currently Jun 18 2013, 5:34am

Login  •  Register
SHOP TALK (Live Chat)
Sitewide News Sitemaps & Feeds