jQuery not supported.



News News of SilveradoSierra.com

Site map of SilveradoSierra.com » Forum : SilveradoSierra.com

Chevrolet Silverado and GMC Sierra trucks... period.

shifted into reverse while driving

i was messing around with my son and he accidentally kicked the shift lever into reverse while we were doing about 40mph. im beyond not happy about this. Drove home....no issues, put in reverse, no issues. Whats the best case/ worst case scenario? is there something i can do to investigate before bringing to a shop?
thank you.
Read more : shifted into reverse while driving | Views : 57 | Replies : 3 | Forum : Transmission/Drivetrain


Cam surge after tune?

Dealing with some cam surge at low speeds. Especially when using power steering. Had the truck tuned it runs great as far as performance goes but I'm dealing with some heavy surging and stalling. I know there will be an aggressive idle feel but I feel this can be tuned out.

I am also noticing at lower cruise speeds like 20mph the idle will hang high around 2000 rpm and almost feel like cruise control ...
Read more : Cam surge after tune? | Views : 25 | Replies : 2 | Forum : Vortec 5300 5.3L V8


6l80 tranny stumper

Ok - bought a 2011 silverado as a back up truck . Have a new 2021 f-250 tremmor, so this truck is kind of a rebuilder, for fun, and for farm use.
Brought home, and see leaks on the front hoses, so made the decision to put on ramps, replace the oil cooler lines, power steering lines, and the front steering gear assembly. I did this in my spare time, so the truck was up ...
Read more : 6l80 tranny stumper | Views : 4 | Replies : 0 | Forum : Transmission/Drivetrain


Stereo system upgrade Stereo system upgrade

I am wanting into upgrading my factory stereo system, because let’s face it the factory setup sucks. The only thing is I would like to keep the factory head unit. Looking for suggestions and opinions on what route I should take.
Read more : Stereo system upgrade | Views : 17 | Replies : 1 | Forum : Mobile Electronics


Door Replacement 2009 3500

Need to replace my driver and passenger front doors on my 2009 3500 WT Crew Cab. What years are they compatible with? Will 1500 doors work?

Thanks!
Read more : Door Replacement 2009 3500 | Views : 42 | Replies : 4 | Forum : Exterior


Help with engine wiring harness

I have a 2012 GMC Sierra 1500 5.3L V8. Unfortunately, I was attempting to go through the firewall and hit several wires and it has become a huge mess. Long story short, after mechanic bills and other issues, I have to replace the wiring harness. My question is this, all of the wiring harnesses I see only go up to the fuse box. I need the wiring that goes through the firewall and up through ...
Read more : Help with engine wiring harness | Views : 59 | Replies : 1 | Forum : Electrical


Long tuber headers for the 2011 and up 6.0

Has anyone found any long tube headers for the 2011 and newer 6.0 trucks?
The chassis did not change so they headers should work for any 2011-2018 6.0 truck.
But I can not find any that list this year range as an option?
Read more : Long tuber headers for the 2011 and up 6.0 | Views : 35 | Replies : 0 | Forum : Vortec 6000 6.0L V8


shout out to the admins

So I'm new here and really wonder what I can do here. It says first post has to be approved by admins, but so far every time I try to post it has to be approved. Not only that but more often than not my posts are not approved, can't post in the classifieds (just trying to reply, not selling), can't send pm's. So what CAN I do?
Read more : shout out to the admins | Views : 69 | Replies : 10 | Forum : Website Concerns


BRand New O2 sensors and Catalytic converters - No readings

I have a 1998 GMC Sierra 2500 7.4L

I have recently replaced all 4 O2 sensors and installed brand new (CARB) compliant catalytic converters. I have also replaced the Max Air flow sensor, thermostat, both coolant sensors. When I hook up my car scan tool all reading everywhere else in the truck seem to be fine. However I am not getting any readings at all from the O2 sensors.

Could this simply be a bad ...
Read more : BRand New O2 sensors and Catalytic converters - No readings | Views : 20 | Replies : 0 | Forum : Exhaust


Oil drain plug torque?

Anyone know the recommended torque for the oil drain plug on the 3.0?

thanks!
Read more : Oil drain plug torque? | Views : 181 | Replies : 13 | Forum : Duramax 3.0 I6


 

Login  •  Register


Statistics

Total posts 1201905 • Total topics 118320 • Total members 117805

It is currently Mar 07 2021, 10:02pm

  • Sponsor
Login  •  Register
Sitewide News Sitemaps & Feeds