Chevy Silverado and GMC Sierra Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 29 Results
  1. 🧰 🛠️Under ConsTRUCKtion
    Well I bought a 2000 Silverado 1500 4x4 with the 5.3l LM7 over a year ago for 4K. It started out rusty and with a misfire, rusted out brake lines and pretty much shite everything. So far I have replaced basically everything except motor/trans, frame and cab. Following is a mostly complete list...
  2. 🙋‍♂️ Member Introductions
    Hey everyone! Here’s my 2009 Silverado 5.3 4x4. Has a 6 inch rough country lift and is currently sitting on 37x 13.50’s on 20x12 LRG Wheels.
  3. Engine
    I have 2005 Silverado with 4.8 good fuel pressure spark on every cylinder I’m gonna check injectors tomorrow but noid light was good on injectors it acts like it’s gonna start then immediately dies any ideas? I’m thinking maybe timing chain but hoped not lol
  4. Interior
    Front driverside door panel - I've got a 2013 Chevy Silverado 1500 and my door panels got the handle & few other pieces ripped off of it. I have a buddy who has a 2013 GMC Sierra 1500 parts truck, are the door panels compatible or not?
  5. 4-Speed Automatic Transmission
    I’ve been noticed a grinding noise more and more lately in my 02 sierra 5.3. It sometimes comes around slightly at idle but I mostly hear it when accelerating and when the rpm’s increase when the trans downshifts. I’ve idled it in neutral and find it will still make that noise so I don’t think...
  6. Vortec 4800 4.8L V8
    Hey there, hopefully someone can guide me in the right direction. I have a 2013 Silverado 1500 LT with the 4.8l. About a month ago I started hearing a top end sounding ticking noise. Would happen when it was cold then be pretty faint once the truck was warmed up. Did not sound like a knock at...
  7. ⚙️ Transmission - Transfer Case - Driveline
    I have a 2008 chevy silverado 1500 2wd and it has spacer lift 3” in front and 2” in back so its leveled. I lifted the truck 4 years ago when i first got it and its been fine since, until i had my rear diff rebuilt from 3.23 to 4.10 gears. The problem is the slip yolk looks like its hanging out...
  8. 🙋‍♂️ Member Introductions
    Obviously I’m new and you can call me Noodles if you like. I live in northern Iowa and I’m a CNC machinist by trade. I’m mechanically inclined and my skill level is 2.5/5 LOL. I’ve been lurking for a while reading up before finally joining a few days ago. I found the forum by researching my new...
  9. Vortec 4800 4.8L V8
    I have a 2008 1500 with a 4.8 with 420,000 miles on the odometer. With such high mileage I’ve been looking for a possible engine swap. I found a 2007 6.2 out of an Escalade. Would this bolt right up? Any help would be greatly appreciated as I am open to any advice.
  10. Exterior - Body - Frame
    Hello everyone. I am new to posting but a frequent viewer of this forum. I'm sorry if this has already been discussed but I can't find anything up to date on this topic, I have been looking all night. I have a 2006 gmc sierra 1500 slt 4x4 non-z71. I recently ripped off my oem plastic front skid...
  11. 2011 Chevrolet Silverado 1500 LS

    My current progress on my project truck. 4.8L 2011 Chevy Silverado 1500 LS Crewcab. Aftermarket for all exterior lighting, sequential rear turn signals and tailgate bar) . -2” drop shackles in the rear, replica 20” snowflakes (-18mm offset), K&N cold air intake series 77, Hypertech tuner, Pedal...
  12. 🛻 Uncategorized Truck Topics
    I have a 2011 gmc Sierra 1500. While going down the road the Speedo jump up and down randomly everything seems to work other than that some times when it bounces it down shift hard. Also scan tools dont work when plugged up.
  13. ⚙️ Transmission - Transfer Case - Driveline
    My 02 Chevy Silverado 1500 was having intermittent problems switching into 4hi. I did some research and tried a new 4x4 actuator, didn’t solve the problem. I noticed when I’d push 4hi my 4lo would flash or when I pushed auto sometimes my 4hi would flash. Took my 4x4 switch out and checked...
  14. 🙋‍♂️ Member Introductions
    New to the forum, and to working on vehicles. I had been given a 2003 Silverado 4.3L V6 WT from mother, who go the vehicle from my grandfather after he passed. Before I took ownership, the truck had sat for EIGHT years on uneven dirt. Luckily, it had a complete tune up before sitting. However...
  15. Exterior - Body - Frame
    Hey y’all new here, so I know Ranch Hand separates the compatibility of their front bumpers for the 1500’s by 2014-2015 & 2016-2018. Is the mounting placement different on them or just the style to conform to the changed headlights? Would I be able to buy a 2015 ranch hand and put It on my 2017...
  16. ⚡ Electrical
    I have a 2009 1500 Silverado and I recently came upon some electrical problems after my battery died. I got a new battery since it was tested and proven bad. I was searching around for the fixes of my electrical problems and I couldn’t find any answers. So I used the “JustAnswer” website where...
  17. ❄️ Climate Control - HVAC
    2014 Silverado 1500 only blowing cold A/C on the passenger side. Ambient Temp is about 78*. Driver's Side Temp set on LO: 73* Passenger Side temp on LO: 56* I've been searching the internet for fixes but my troubleshooting has left me coming up empty handed and I figured I should take a...
  18. Vortec 5300 5.3L V8
    so I just bought a fuel pressure test gauge to check my fuel pressure and when I turn the key over a couple of times the fuel pressure is at 70-75 psi which I know these trucks usually are around 55 psi and when I crank the truck it will jump to 80-90 fluctuating back and forth turn the truck...
  19. ❄️ Climate Control - HVAC
    I was trying to locate my low pressure valve for my AC compressor and noticed this line going to nowhere? Should it be connected to a vacuum line or is it just some sort or release line? Located right under the AC accumulator. I just got my 2012 Chevy Silverado 1500 5.3L V8 and would appreciate...
1-20 of 29 Results
Top