Search Results for ‘exhaust’

First time with this truck during winter so not used to the cold. Looking for any answers here. It’s 28 degrees, trucks been on for 40 minutes, driving for 20, idling for 20. It’s completely warm and still smoking. as someone who’s not familiar mechanically, what could be the cause? I feel like...

I have standard 2020 Silverado 1500 5.3, I want deep & loud exhaust tones with absolutely no rasp or crackling whatsoever. I like flowmaster and was thinking about the super hp2. Thoughts? Anybody run this setup? Also I want it deep and loud, but I’d rather have that deep throaty sound and...

Hey yall, so I bought a truck from a wisonsin dealership yesterday and drove it back and hour and half to where I live. when I went to go park on my up hill driveway, I noticed a noise coming from under the engine near the exhaust on the driver side. makes a can rattle at low rpms and when truck...

2022 Chevy Silverado 1500 RST 6.2L. I’ve started my build with the corsa exhaust and volant CAI getting installed today. I’m waiting on my lift, wheels and tires to arrive so we can start on that next. But I will be selling the factory wheels/tires, original exhaust, factory intake and running...

I recently had my catalytic converters stolen out of my 2011 Silverado for the 2nd time in 2 years. I can’t afford to keep replacing them so the local scumbags can steal them again and again. So I’m opting for the route of just using an off-road y pipe with no cats. I’m wondering if that would...

Hey guys, got a good one for you. So I brought my 2012 Silverado to a shop and had them install a custom grind Texas Speed 228R with 110LSA along with a 2800-3000 Circle D stall. I’ll post full build under this post. Well they are done with the install and are having a problem with the truck...

I've pretty much narrowed my exhaust decision down to these 2. The Proven Ground C&L series 3" or the MBRP 3" installer series. They look and sound similar as far as I can tell. Prices are similar as well. Looks like the Proven Ground is 409 stainless and the MBRP is aluminized steel, does that...

I’m looking to install a magnaflow 18” 12259 3” in and out myself with clamps to make sure I like it before I go have it welded. I’ve got a 2018 5.3 Sierra. I’m going to leave everything else stock and in place and I’ll probably clamp open the valve. Just want to sound like a truck. Nothing...

Hello everyone new here, but coming with a question. Recently got an aftermarket exhaust on my Silverado 5.3 that provides a nice yell when going, with a few pops and crackles here and there but are then immediately cut off, or never occurs at all. Thinking this may have to do with the AFM does...

My car has an afe air intake, Arh headers, tsp custom cam kit 222/230 and a tune but with the stock exhaust it sounds terrible and with a Magnaflow exhaust it’s tooooooo loud. Any suggestions?