I have tested OBD with my cheap OBD2 from Princess Auto(AutoLink AL301) and a more robust model from Lordco(Innova 1003f). There are no codes and none stored as reported from both readers. After driving "My Son's" truck, I cannot discern any driving issues other then the 3 dash codes mentioned. The only condition leading up to this was he was driving with a slow leak and the TPMS sensor was reporting a low tire. He drove with the spare for some time until he had the tire repaired. Since replacing the tire, I have driven the vehicle for approximately 30km and the ABS error should have cleared. I am focusing on the ABS error as it may also be the cause for the other 2 dash messages. Here's what I have done:
My nest step I need help with:
I may have to pay to get this scanned, but it has been frustrating as both scanners report successful connection and scan with the same results AND there are no apparent driving issues.
Appreciate any tips!
HJD
- disconnect the battery at the negative (going to try positive with a drain function: ie, turn on the key)
- checked the brake fluid level
- inspected all wheel hubs and harnesses and ABS Control module
My nest step I need help with:
- inspect and clean all ground points, specific to ABS system - where are they?
- test wheel sensor leads for some level of resistance. What is that level and where is the junction connect point?
- check for noise at the ABS control module, make sure it is active (2 people)
I may have to pay to get this scanned, but it has been frustrating as both scanners report successful connection and scan with the same results AND there are no apparent driving issues.
Appreciate any tips!
HJD
