Hello all. I was reading through this post here: rough country ball joint boot since I have the same exact issue. However, I bought my control arms in 2019. My design is the beefier, more squarish design as opposed to their original, all rounded arm design.
My question is, is the ball joint itself still the same? I am looking into ordering the boots in that post but wanted to make sure they are the same before I do so. I have installed 2 ball joints on the drivers side now due to the boot tearing on install
and at this point would prefer to replace the boot rather than the ball joint that is brand new.
Here are the boots that OP linked in the thread I linked. Ball Joint Dust Boots - Chevrolet Corvette - 9.13127
My question is, is the ball joint itself still the same? I am looking into ordering the boots in that post but wanted to make sure they are the same before I do so. I have installed 2 ball joints on the drivers side now due to the boot tearing on install
and at this point would prefer to replace the boot rather than the ball joint that is brand new.Here are the boots that OP linked in the thread I linked. Ball Joint Dust Boots - Chevrolet Corvette - 9.13127
