Chevy Silverado and GMC Sierra Forum banner
1 - 8 of 8 Posts

· Registered
Joined
·
301 Posts
Discussion Starter · #1 ·
Replacing my factory horns after using it and realizing it sounded bad... so, disassembling my truck and it turns out that I'm missing a horn?

There should be a low tone and a high tone horn, one on each side.. yet the passenger one is missing?
 

· Registered
Joined
·
301 Posts
Discussion Starter · #3 ·
No wiring, no brackets.
The passenger side was hit before but didn't realize it after the purchase and didn't get a good look at the repaint of the passenger side doors till after.

You think when they were repairing, they just didn't reinstall the horn?
 

· Servicemen, TOTM
2015 Sierra SLE 5.3 4x4
Joined
·
7,671 Posts
Alderson said:
Got the new horns installed and just ran some wiring to the existing horn on the driverside.
You just had to go and toot your own horn didn't you?
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top