Chevy Silverado and GMC Sierra Forum banner
1 - 7 of 7 Posts

· Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Newbie here, but here is the setup. I have an 1982 Chevy C10. I have access to an 1988 GMC Sierra that has a Fuel Injected 350 in it. I want to take the GMC motor and modify it to a carbureted motor, then install it into my 1982 Chevy.

What I need from the group is information about the feasibility. The only thing thatI need to do is buy a intake manifold for the 1988 350, so that it could be carbureted? What else do I need to look out for? Is it even probable?
 

· Registered
Joined
·
2,304 Posts
I guess that really depends on the condition of either one. Go with the one you think is best. While your doing this it might make sense to look at a new torque converter while it's apart if you can afford to. Also look at the flex plate starter teeth and pick the best one.
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top