Boat, trailer... - Thanks tinner. We're looking forward to a quick first trip, just to make sure we can set up and tear down without issues.

Thanks tinner. We're looking forward to a quick first trip, just to make sure we can set up and tear down without issues.

I pulled it, I did

Dragged the ol Camaro all over to try and find good body shop for the paint. About 80 miles to 4 shops later, one was "nope, too busy", two were around 6,000 and one was 15,000. And that's not even counting the shops that flat out said "no hot rods, just collision". Who knew it would be so hard to get someone to take my money?



I also gopro'd a POV since the Camaro hasn't seen road miles in forever! hahaha Shots came out kinda cool.

2019 GMC Sierra 2500HD
2019 Jayco SLX 212QB

Put her to work this past weekend.
Moved 154 in Saturday 6am-6pm, and the last 28 Sunday morning.

Never saw over 190deg trans temps and the 4.56s pulled like a champ and the truetrac performed well as well. I should have taken a picture of the pasture with rolling hills, could not go up one of them straight without needing 4x4... which I don't have so I went up at an angle.

Bradley21sanders wrote:Put her to work this past weekend.
Moved 154 in Saturday 6am-6pm, and the last 28 Sunday morning.

Never saw over 190deg trans temps and the 4.56s pulled like a champ and the truetrac performed well as well. I should have taken a picture of the pasture with rolling hills, could not go up one of them straight without needing 4x4... which I don't have so I went up at an angle.

can you go in to your experience with the truetrac a bit more? one may replace my g80 one day. did you have any slippage one side to another, or did it keep both spinning at the same speed?
(I am aware that it is a helical gear no clutch limited slip blah blah design talk, but am interested in the real world functionality)

I got out and looked at a few of the tracks after making it up the hills but not all of them.
But to my knowledge there were no one wheel peeling on the hills.

There were a few times I started to spin too much and start sliding (keep in mind I'm going up the side of a hill at an angle) so I would let off a little and it would get a better bite again.

For comparison anytime my cousin would start spinning it was one or both wheels and then he would just lock it in 4x4

First post with the new (to me) truck. No complaints about the 6.0 vortec.

During a pandemic this is the only way to travel.
Our bed, our food our everything.